The Bed

On 2/17/2012 we figured out how to raise the bed 2 inches.  We took the angle strips, flipped them upside down, created 2 inch spacers between the cross-sills and font/rear bed panels.  I'm going to buy 2 extra stainless bed strips to cover the spot where the angle strips would have been.  We are also going to build an aluminum cover at the rear.  When you open the tailgate, you will see that the bed is 2 inches taller and not flush.  The aluminum cover will hopefully make this look a little better.  Raising the floor gives the rear more suspension travel and allow me to lower the rear even more.